Step 10
: Fold the bottom corner of the upper layer up then flatten.
Step 11
: Fold both lower-left and lower-right edges to the center line,then trun over.
Step 12
: Repeat step11.
Step 13
: Rotate the model vertically 90 degrees, perpendicular to the desktop.
Step 14
: Fold both left and right side of model to the center line as shown below.
Step 15
: Fold the bottom corner of the upper layer to the top corner.Repeat the same step at the behind side.
Step 16
: Rotate the model vertically 90 degrees, perpendicular to the desktop.
Step 17
: Fold both left and right side of model to the center line as shown below.
Step 18
: Rotate the model vertically 90 degrees, perpendicular to the desktop.
Step 19
: Pull out the bird wings as shown below.
Step 20
: Make reverse inside fold to make the bird head.
Pages: 1 2