Origami boar face instruction and diagram

Learn how to make an easy origami boar face.Follow the instruction below to make it.It’s very simple and very suitable for beginners.The diagram and easy step-by-step instructions below will guide you easily finished it.

1. Start with the white side of the paper facing up.Fold in half by fold the top corner to the bottom corner.
2. Fold in half by folding the right corner to left corner.
3. Fold the left corner of the upper layer to the lower corner and pull the center line to the right.
4. Flatten.
5. Turn over.
6. Repeat step 3 to step 4.
7. Make a crease by folding the top corner to the lower corner,then unfold.
8. Fold the lower corner of the upper layer up and through the center point.
9. Fold the top corner of the upper layer behind along the dotted line.
10. Fold the lower corners of the middle layer up along the dotted line.
11. Turn over.
12. Make creases along the dotted line as shown below.
13. Open and flatten the upper layer along the dotted line.
14. Fold both corners of the upper layer to cerner point along the dotted line.
15. Fold the top corner to the cerner point.
16. Turn over.
17. Draw a face and spots and finished.

Step 1

:Start with the white side of the paper facing up.Fold in half by fold the top corner to the bottom corner.

Step 2

:Fold in half by folding the right corner to left corner.

Step 3

:Fold the left corner of the upper layer to the lower corner and pull the center line to the right.

Step 4

:Flatten.

Step 5

:Turn over.

Step 6

:Repeat step 3 to step 4.

Step 7

:Make a crease by folding the top corner to the lower corner,then unfold.

Step 8

:Fold the lower corner of the upper layer up and through the center point.

Step 9

:Fold the top corner of the upper layer behind along the dotted line.

Step 10

:Fold the lower corners of the middle layer up along the dotted line.

Step 11

:Turn over.

Step 12

:Make creases along the dotted line as shown below.

Step 13

:Open and flatten the upper layer along the dotted line.

Step 14

:Fold both corners of the upper layer to cerner point along the dotted line.

Step 15

:Fold the top corner to the cerner point.

Step 16

:Turn over.

Step 17

:Draw a face and spots and finished.